motore passo passo (28BYJ – 48 – 5 V) per Arduino, 5 V, a 4 fasi, 5 fili, con driver board ULN2003 RBTMKR

The wiring method for stepping motor:

Left 1 N 1 ~ 1 N 4 connect to the four corresponding IO wires of MCU.

The right black pins are defined from top to VCC, A, B, C, D (connect to the concentric line, phase A, B, C, D of stepping motor).

Power supply method:

Connect short circuit jumper, choose 5V as the working voltage for stepping motor/DC motor. Take off short circuit jumper, stepping motor/DC motor can choose external voltage for power supply via pins.

ULN2003 Driver Board

High-power stepper motor driver chip.

A, B, C, D four-phase LED indicates the status of the stepper motor work.

Stepper motor with a standard interface, when used directly pluggable.

Drive Module Board Size: 35mm x 31mm x 11mm Barebone, Componenti, Informatica 5V Stepper Motor and motor driver board, Rated Voltage: DC5V 4-phase Reduction Ratio: 1/64, Step Torque Angle: 5.625/64, DC Resistance: 200Ω±7% (25C), Insulation Resistance:;10MΩ (500V), Dielectric Strength: 600V AC / 1mA / 1s, Insulation Grade: A, Temperature Rise: <40K (120Hz), No-load Pull in Frequency: ;600Hz, No-load Pull out Frequency: ;1000Hz, Pull in Torque: ;34.3mN.m (120Hz), Detent Torque: ;34.3mN.m

Il prezzo di motore passo passo (28BYJ – 48 – 5 V) per Arduino, 5 V, a 4 fasi, 5 fili, con driver board ULN2003 RBTMKR è 5.99 € . Questo prodotto appartiene alla RBTMKR


Prodotti relativi a stepper high power

This site collects anonymous statistical data on navigation through cookies installed by authorized third parties, respecting privacy of your personal data and in accordance with standards established by law. By continuing to browse this site, clicking on links in it or simply shaking the page down, you agree to the service and the same cookie. More informations

Accept Cookies Cookies Policy